Table of Contents
Advertisement
U p g r a d i n g Y o u r S y s t e m
Removing
1.
Unplug all cables connected to the board.
2.
Remove the securing screw and pull the board out of the slot,
leaving an empty space on the rear panel for the blanking plate
again.
3.
Secure a blanking plate to cover the access opening.
4.
Run the System Configuration Utility to inform the system that you
have removed the board.
Fitting Hard Disk Drives
SH-7b
The Disk Subsystem contains all the hard disk drives for the server. The
system will accommodate up to 20 drives, all of which are hot pluggable.
This means that you can fit a drive without having to power the machine
down first.
The disk subsystem is located on the right side of the machine when
viewed facing the front panel. The following illustration shows the entire
subsystem, with the protective metal plate removed from the upper half of
the disk chamber:
1
Figure 3-10 Disk Subsystem
1.
Disk Subsystem
3-12 OWNER'S HANDBOOK
2.
Cooling Fan Assemblies
2
Advertisement
Table of Contents
