Removal 19 Size Switch Assembly (Pl7.1.18) - Dell 3110cn Service Manual

Removal 19 SIZE SWITCH ASSEMBLY (PL7.1.18)

Steps 1 through 4 are for reference. Before removing this component, check that Steps 1 through 4
have been performed.
1) Open the FRONT COVER (PL1.2.1).
2) Remove the FUSER. (Removal 8)
3) Remove the REAR COVER. (Removal 12)
4) Remove the RIGHT COVER. (Removal 13)
6)
7)
5) Release the clamp on the SIZE SWITCH ASSEMBLY (PL7.1.18), and then remove the har-
ness.
6) Disengage the connector (P/J231) of the SIZE SWITCH ASSEMBLY.
7) Remove the one screw (silver, tap, 10mm) that fixes the SIZE SWITCH ASSEMBLY to the
printer.
8) Remove the SIZE SWITCH ASSEMBLY by releasing the two bosses and the backside tab of
the SIZE SWITCH ASSEMBLY from the holes on the printer.
9) Remove the clamp from the SIZE SWITCH ASSEMBLY.
Version 2 2006.03.31
5)
9)
8)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 38
Kmy03029KA