Removal 21 TONER CARTRIDGE SENSOR ASSEMBLY (C), (M), (Y) (PL5.1.4)
Described below is the removal procedure common among TONER CARTRIDGE SEN-
SOR ASSYs (C), (M), and (Y).
Steps 1 through 4 are for reference. Before removing this component, check that Steps 1 through 4
have been performed.
Open the FRONT COVER (PL1.2.1).
Remove the FUSER. (Removal 8)
Remove the REAR COVER. (Removal 12)
Remove the RIGHT COVER. (Removal 13)
Remove the one screw (silver, tap, 10mm) that fixes the TONER CARTRIDGE ASSEMBLY
(PL5.1.4) to the printer.
Remove the TONER CARTRIDGE ASSEMBLY from the printer.
Disconnect the connector of the TONER CARTRIDGE ASSEMBLY.
Version 2 2006.03.31
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 40
SENSOR ASSEMBLY (C)
SENSOR ASSEMBLY (M)
SENSOR ASSEMBLY (Y)