Removal 22 LEFT COVER (PL1.1.7)
Steps 1 through 3 are for reference. Before removing this component, check that Steps 1 through 3
have been performed.
1)
Open the FRONT COVER (PL1.2.1).
2)
Remove the FUSER. (Removal 8)
3)
Remove the REAR COVER. (Removal 12)
4)
5)
6)-2
4)
Remove threescrews (silver, tap, 10mm) that fix the LEFT COVER (PL1.1.7) to the printer.
5)
Release the two holes on the LEFT COVER from the bosses on the printer.
6)
Release the one backside hook and two front side hooks on the LEFT COVER, and then
remove the LEFT COVER from the printer by moving it diagonally backward.
Go to the next removal step:
Removal 23 ELECTRONIC SUB-SYSTEM CONTROL BOARD (PL9.1.27), Removal 24 LEFT
ARM ASSEMBLY(PL7.1.97) (PL7.1.97), Removal 25 LED ASSEMBLY (PL5.1.15), Removal
26 TONER DISPENSER MOTOR (PL5.1.12), Removal 27 SHIELD ASSY ESS (REFERENCE
ONLY) or Removal 30 TOP COVER (PL1.1.1)
Version 3 2007.03.15
Chapter 3 Removal and Replacement Procedures (RRPs)
6)-1
4)
5)
6)-1
6)-1
4)
3 - 41
Kmy03032KA