Dell 3110cn Service Manual page 339

Removal 36 PHOTOCONDUCTOR (PC) / DEVELOPER (DEV) DRIVE (PL8.1.2)
8) Remove two screws (silver, tap, 10mm) that fix the BRACKET FUSER (PL6.1.12) to the
printer.
When performing the step described below, take care not to move the BRACKET FUSER
from the printer too far because they are connected with the harness.
9) Remove the BRACKET FUSER from the printer.
10) Release the harness of the PHOTOCONDUCTOR (PC) / DEVELOPER (DEV) DRIVE
(PL8.1.2) from the DUCT DRV MAIN (PL8.1.9).
11) Remove the one screw (silver, tap, 10mm) that fixes PHOTOCONDUCTOR (PC) / DEVEL-
OPER (DEV) DRIVE to the printer.
12) Remove the DUCT DRV MAIN from the PHOTOCONDUCTOR (PC) / DEVELOPER (DEV)
DRIVE by releasing the bosses on the DUCT DRV MAIN and sliding the DUCT DRV MAIN
backward.
13) Disengage the four connectors (P/J211, P/J221, P/J222, and P/J2761) from the PHOTOCON-
DUCTOR (PC) / DEVELOPER (DEV) DRIVE.
14) Remove the harness from the PHOTOCONDUCTOR (PC) / DEVELOPER (DEV) DRIVE
together with the clamp.
Continues to the next page.
Version 2 2006.03.31
Chapter 3 Removal and Replacement Procedures (RRPs)
9)
13)
13)
13)
13)
14)-1 14)-1
14)-2
3 - 65
8)
8)
10)
12)-1
12)-2
11)
Kmy03051KB