Removal 18 Right Arm Assembly (Pl13.3.98) - Dell 3115cn Service Manual

Removal 18 RIGHT ARM ASSEMBLY (PL13.3.98)

Steps 1 through 7 are for reference. Before removing this component, check that Steps 1 through 7
have been performed.
1) Open FRONT COVER (PL13.2.1).
2) Remove the FUSER.(Removal 8)
3) Remove the REAR COVER. (Removal 49)
4) Remove the COVER BOTTOM. (Removal 50)
5) Remove the COVER POLE IN R.(Removal 51)
6) Remove the COVER POLE R.(Removal 52)
7) Remove the RIGHT COVER. (Removal 54)
8) Release the hook of the SHAFT PIVOT (PL13.2.10) that fixes the LINK R (PL13.3.20) to the
FRONT COVER (PL13.2.1), and then pull the SHAFT PIVOT to the outside and remove the
LINK R from the FRONT COVER.
9) Remove three screws (silver, tap, 8mm) that fix the SUPPORT LINK R (PL13.3.15) to the
printer.
10) Remove the SUPPORT LINK R from the printer.
Continues to the next page.
Version 2 2007.03.20
Chapter 3 Removal and Replacement Procedures (RRPs)
8)-3
8)-2
8)-1
3 - 32
9)
10) 9)
9)
Gnb03027KA