Wall Mounting The Charging Unit; Figure 2-134 Placing The Telephone Cords Inside The Wall Mount Stand; Figure 2-135 Attaching The Wall Mount Unit To The Wall - NEC SL1100 Hardware Manual

ISSUE 5.0
4. Plug one end of the short telephone cord into the LINE jack on the base unit. Then plug one end
of a SL1100 multiline terminal into the PHONE jack. Place the telephone cords inside the molded
channels on the bottom of the wall mount stand.

Figure 2-134 Placing the Telephone Cords Inside the Wall Mount Stand

5. Place the base unit on the posts of the wall screws and push down until it is firmly seated.
6. Plug the other end of the short telephone cord into a telephone wall jack.
7. Plug the AC adapter into a standard 120 Vac wall outlet. Refer to
Adapter into the AC Wall Outlet on page
Do not use an outlet controlled by a wall switch.

6.1.7 Wall Mounting the Charging Unit

The charging unit can be wall mounted as well. Before mounting the charging unit, consider the
following:
• Select a location away from electrical cables, pipes, or other items behind the mounting location that
could cause a hazard when inserting screws into the wall.
• Make sure the wall material can support the weight of the charging unit.
• Use #10 screws with anchoring devices suitable for the wall material where the charging unit will be
placed.
To mount the charging unit:
Hardware Manual

Figure 2-135 Attaching the Wall Mount Unit to the Wall

2-92.
Figure 2-132 Plugging the AC
SL1100
2-93