Figure 3.19 Example Of [Add Sb/Iou To Partition] Window - Fujitsu PRIMEQUEST 2000 Series Installation Manual

CHAPTER 3 Work before Operating System Installation
3.4 Partition Configuration (Physical Partition)
4. Click the radio button of one SB or one IOU to add it to the partition.
5. Only one SB or one IOU can be selected by one operation.
6. Click the [Apply] button.
→Confirmation dialogue box is displayed.
7. Click [OK] button.
→The selected one SB or one IOU is added in the partition.
Repeat procedure 2~6 until you have added all the required SBs or IOUs.
Removing of SB and IOU
This section describes the method of removing the SB or IOU from the partition.
Remark
You cannot remove a SB or IOU while the operating system on the target partition is running. Remove the SB or IOU while
the partition is in the POWER OFF status.
Operations
1. Click [Partition] - [Partition Configuration]
→ [Partition Configuration] window is displayed. For details of [Partition Configuration] window, see "1.3.3 Partition
Configuration] window" of PRIMEQUEST 2000 series Tool Reference (CA92344-0539).
Example of [Add SB/IOU to Partition] Window
FIGURE 3.19
33
CA92344-0536-01