Setting Of Reserved Sb; Figure 3.23 Example Of [Reserved Sb Configuration] Window - Fujitsu PRIMEQUEST 2000 Series Installation Manual

CHAPTER 3 Work before Operating System Installation
3.4 Partition Configuration (Physical Partition)

3.4.3 Setting of Reserved SB

If hardware failure occurs in the SB which is added in the partition and it may be necessary to remove the SB. Reserved
SB is an SB which is newly added in the partition instead of removal of SB.
To configure Reserved SB in partition, following points should be considered. SB which is not added in the specified
partition can be defined as Reserved SB.
The following SB is not added in the partition.
- SB in free status
- SB added in other partitions
- SB defined in Reserved SB of other partitions
For details of Reserved SB, see "3.2.3 Reserved SB" of PRIMEQUEST 2000 series Administration Manual (CA92344-
0537).
Remark
- Flexible I/O mode configuration is required to implement the Reserved SB.
- Windows license verification is required depending on the combination of SB and enables kit. For details "Activation
depending on the combination of SB and enable kit" of "3.4 Component extension" of PRIMEQUEST 2000sSeries
Administration Manual (CA92344-0537).
Operations
1. Click [Partition]-[Reserved SB Configuration]
 [Reserved SB Configuration] window is displayed. Check box is displayed vertically in the free status SB column
or the column of SB which is defined as Reserved SB. For details of [Reserved SB Configuration] window, see "1.3.5
[Reserved SB Configuration] window" of PRIMEQUEST 2000 series Tool Reference (CA92344-0539).
2. Check the checkbox of the partition to be reserved in SB column.
3. Click [Apply] button.
FIGURE 3.23 Example of [Reserved SB Configuration] Window
37
CA92344-0536-01