Figure 3.21 [Add Sb/Iob/Gspb To Partition] Window (Example) - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
CHAPTER 3 Work before Operating System Installation
Partition] window in 1.3.4 [Partition Configuration] window in the PRIMEQUEST 1000 Series Tool
Reference (C122-E110EN).

FIGURE 3.21 [Add SB/IOB/GSPB to Partition] window (example)

4. Click the radio button of an SB, IOB, or GSPB to add it to the partition.
Only one SB, IOB, or GSPB can be selected at a time.
5. Click the [Apply] button.
>> A confirmation dialog box appears.
6. Click the [OK] button.
>> The partition incorporates the selected SB, IOB, or GSPB.
Repeat steps 2 to 6 until you finish adding all the required SBs, IOBs, and GSPBs.
Removing an SB, IOB, or GSPB
The following describes how to remove an SB, IOB, or GSPB from a partition.
Remarks
You cannot remove an SB, IOB, or GSPB while the operating system on the target partition is running. Remove
the SB, IOB, or GSPB while the partition power is in the standby status.
Operations
1. Click [Partition] - [Partition Configuration].
>> The [Partition Configuration] window appears. For details on the [Partition Configuration] window, see
1.3.4 [Partition Configuration] window in the PRIMEQUEST 1000 Series Tool Reference (C122-E110EN).
44 C122-E107-09EN