Preparation For Installation; Installation Of Operating System; Table 4.1 Operating System Installation By Svim - Fujitsu PRIMEQUEST 2000 Series Installation Manual

CHAPTER 4 Installation of Operating System and bundled software
4.3 Procedure to install Windows in SAN/iSCSI storage device

4.3.2 Preparation for installation

The following preparations are done.
1. The following disk images should be prepared.
Media of Windows operating system
2. FC cable is made a single path (Connection of only 1 FC cable).

4.3.3 Installation of operating system

Operating system installation by SVIM is explained.
There are the following types in the operating system installation by SVIM. For the detailed procedure of the respective
modes, see ServerView Suite ServerView Installation Manager.
Mode Function Overview
Quick The operating system can be installed in the state recommended by
Mode Fujitsu by only executing the required minimum settings.
Guide It is set according to wizard set up information. The information that was
Mode set, is saved in a configuration file and can be used at the time of re-
install
All the inserted windows are examples of display and the contents displayed by the system configuration, etc. are different.
Operations
1. Make the settings by which the ServerView Suite DVD is booted from the virtual media for the partition.
For settings, see"1.6.2 Remote control operation (BMC)" of PRIMEQUEST 2000 series Administration Manual
(CA92344-0537).
2. The power supply of the partition is turned on.
Notes
It can be started by selecting "Force boot from DVD" by Boot Selector or it can be started from the virtual media by
changing the boot order to DVD by UEFI.
When the operating system corresponds to UEFI mode then the installation can be done in the UEFI mode by
changing the boot order by the following procedure.
a. After the power supply of partition is turned on, press any key (such as the [Space] key except the [Enter] key
until the Fujitsu logo is displayed and the Boot Manager front page is displayed when any key (such as the
[Space] key) is pressed.
b. The menu is selected in the following order by the Boot Manger front page. [Boot Maintenance Manager]- [Boot
Options]- [Change Boot Order]- [Change the order]
c. For UEFI aware OS, UEFI: Fujitsu Virtual CDROMx xxx is set at the upper-most step.
For Legacy OS, Fujitsu Virtual CDROMx xxx is set at the upper-most step.
For the Boot order setting method, see " Change of priority level (Change Boot Order)" of "3.5.2 [Boot
Options] menu" of PRIMEQUEST 2000 series Tool Reference (CA92344-0539).
d. [Commit Changes and Exit] – [Reset System] is specified and the partition is rebooted.
3. After a period of time, the language selection window is displayed. In case of English, select "English".
4. Click the "Next" button without setting anything on the initial display window.
5. [Deployment] is selected by the [To Welcome ServerView Installation Manager].
6. Installation mode is selected, operating system to be installed is selected and the operating system is set.
Remark
IP address of LAN cannot be set by the setting of operating system. Set the IP address after operating system
installation.
7. Click "Installation start-up".
The installation starts.
8. It is replaced to the installation medium of operating system according to the SVIM instruction.
TABLE 4.1 Operating system installation by SVIM
Objective
This mode is used when
operating system is easily
installed.
This mode is used for
advanced setting of RAID and
operating system.
63
CA92344-0536-01