Fujitsu PRIMEQUEST 2000 Series Installation Manual page 66

CHAPTER 3 Work before Operating System Installation
3.4 Partition Configuration (Physical Partition)
Note
- Confirm the I/O space is allocated in the SAS device (SAS card, RAID card, RAID card in DU or RAID card in SB) of a
relevant partition.
Further, also confirm the allocation of the I/O space to the FC card, onboard LAN and LAN Card (Only the card for the
boot passing), while installing on the SAN storage device.
SAS device is displayed as "Device: SAS", and the FC device is displayed as "Device: Fibre". When I/O space is not
allocated, operate [I/O Space Assignment Configuration] menu and remove the allocation of LAN and fibre channel.
However, do not remove the allocation of I/O space for the FC card onboard LAN and LAN Card used for installation,
when the operating system is installed for the storage in SAN environment.
- Confirm whether the Boot device used in the relevant partition is recognized in the UEFI. For confirmation, see
"3.3[Boot Manager] menu" of PRIMEQUEST 2000 series Tool Reference (CA92344-0539). Identify the Boot device
by operating the [Boot Manager] menu when the Boot device is not recognized by the UEFI.
- A confirmation dialog box is displayed, When the DIMM configuration mismatches Reserved SB and the partition,.
When switched to Reserved SB, warning message containing the reasons for releasing Memory Operation Mode is
shown and confirm whether to continue the settings.
For details on [Mode] window, see " [Mode] window" of "1.3.8 [Partition#x] menu" of PRIMEQUEST 2000 series Tool
Reference (CA92344-0539).
43
CA92344-0536-01