Setting Of Connection For Actual Operating Environment; Figure 3.2 Location Of Mmb User Port - Fujitsu PRIMEQUEST 2000 Series Installation Manual

CHAPTER 3 Work before Operating System Installation
3.3 Connection and Setting of MMB
Web-UI of MMB can be accessed from MMB console PC through LAN.
Remark
Use set https command to enable https.
7. Enable telnet by using set telnet enable command.
8. Set date and time as required.
Use the following commands.
Administrator> set date MMDDhhmm[[CC]YY][,ss]
Example: To set 2013/7/27 as date and 13:10:00 as time

3.3.3 Setting of Connection for Actual operating Environment

According to the following operations, set the connection environment for the actual operation.
- Set IP address of MMB console PC
- Connect MMB console PC to the User port of the MMB
- Connect external LAN of PRIMEQUEST 2000 series
Setting of IP address of MMB console PC
Set the IP address of the PC used as the MMB console. See the Manual of the PC to be used for the setting method.
Connection of MMB console PC to the user interface of the MMB
Connect the MMB console PC to the user port #0 of the MMB using LAN cable. Once it is connected, communication
between MMB console PC and MMB is possible via LAN.
Connection of External LAN of PRIMEQUEST 2000 Series
Configuration of external LAN connection of PRIMEQUEST 2000 series and the notes for external LAN connection are
described below. Connection to an external LAN is recommended after setting the security. For details on security, see
"6.5 Set up of security"
.
Location of MMB user port
FIGURE 3.2
14
CA92344-0536-01