Outer Tub Front Panel - ALLIANCE HWF561*E1102 Service

Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
MOTOR
MOUNTING
BRACKET
PIVOT
BOLT

59. OUTER TUB FRONT PANEL

a. Unlock control panel. Refer to Figure 17, Step
1.
b. Pull top of control panel away from control
cabinet far enough to allow lifting control panel
up and off rail support of the control cabinet.
Refer to Figure 17, Step 2.
c. Remove control panel away from control
cabinet. Refer to Figure 17, Step 3.
d. Remove 2 screws holding front of cabinet top to
top front edge of control cabinet front. Refer to
Figure 19.
108
ADJUSTING
BOLT
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
INNER
BASKET
PULLEY
PIVOT
BOLT
ADJUSTING
BOLT
1/4 INCH
METAL
ROD
GROUND
WIRES
Figure 37
e. Working through control panel opening,
remove 2 screws holding bottom flange of
control cabinet front to top flange of front
panel. Refer to Figure 23.
f. If area or space permits, lift cabinet top to a
vertical position by hinging top on the rear
hinges.
NOTE: To avoid damage to hinges, be sure to
support cabinet top with a small chain or something
similar. Refer to Figure 21.
MOTOR
PULLEY
WIRE
HARNESS
W003
BELT
FLW1119S
800168