ALLIANCE HWF561*E1102 Service page 103

To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
Screw
Wire
Clamp
Ring
Spring
Figure 32
i. Open loading door. Carefully remove wire
clamp ring from groove with small flat
screwdriver. Spring is in 6 o'clock position.
Refer to Figure 32.
NOTE: To avoid damage to spring, use screwdriver
on wire clamp ring to the right or left of spring.
j. Grasp loading door seal lip. Refer to Figure 33,
Step 1.
NOTE: To avoid damage to door seal, DO NOT use
pliers or sharp objects to grasp the door seal lip. If
lip is damaged, seal will leak.
800168
Screw
Door
Seal
H205SE1A
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
k. Using a circular motion, pull seal up
(Figure 33, Step 1), out (Figure 33, Step 2) and
down (Figure 33, Step 3).
l. When seal releases from lip of front panel, pull
out and remove the seal. Refer to Figure 33,
Step 4.
NOTE: The ease of installation of the loading door
seal can be improved using water or soapy solution
to work seal around circumference of loading door.
Be sure to orientate seal with the tab in the 12
o'clock position when installing the wire clamp ring
to front panel. Be careful not to overstretch tension
spring.
m. Remove front panel (with loading door
attached) away from washer as far as wires
permit.
n. Unplug wire harness from both the door latch
switch and from the door switch. Refer to
Figure 31. Remove clips holding wire harness
and door seal hose along top flange of front
panel and remove front panel.
NOTE: Door seal hose and wire harness must be
reinstalled in the appropriate clips and holes along
top flange of front panel. Refer to Figure 35.
IMPORTANT: Before reinstalling door and front
panel assembly, make sure the door catch lines up
with the door latch switch. If adjustment is
required, refer to Paragraph 66.
Section 5 Service Procedures
W003
101