Cleaning Non-Electronic Coin Drop - ALLIANCE HWF561*E1102 Service

Section 6 Adjustments
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
67. CLEANING NON-ELECTRONIC COIN
DROP
a. Disconnect electrical power to machine and
drop.
b. Remove coin drop from machine.
c. If lint is preventing coins from rolling through
coin drop, blow compressed air though coin
entry and along the side of the coin drop.
Refer to Figure 49.
Cotter
Pin
Compressed
Air
Figure 49
d. Insert a coin through the coin drop. If coin
does not roll through drop, continue with the
following.
e. Remove cotter pin from top of drop. Refer to
Figure 49. Save pin for reinstallation when
cleaning is complete.
f. Move metal clip closer to sensor so that it
comes off frame. Refer to Figure 49.
123
Metal
Clip
DRY3B
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
g. Remove coin return from coin drop frame.
Refer to Figure 50.
Coin
Return
h. Check coin path in coin drop for lint and
residue. If lint or light residues are present,
use a cotton swab to remove. If heavy residue
is present, it may be necessary to first scrape
off excessive residue and then use a cotton
swab dipped in water or isopropyl alcohol
(rubbing alcohol) to remove remainder of
residue. Refer to Figure 51.
Coin Drop
Frame
DRY4B
Figure 50
Cotton
Swab
DRY5B
Figure 51
W003
800168