Control Cabinet Wrapper; Lower Access Panel - ALLIANCE HWF561*E1102 Service

To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.

48. CONTROL CABINET WRAPPER

a. Unlock control panel. Refer to Figure 17, Step
1.
b. Pull top of control panel away from control
cabinet far enough to allow lifting control panel
up and off the rail support of the control
cabinet. Refer to Figure 17, Step 2.
c. Remove control panel away from control
cabinet as far as wires permit. Refer to
Figure 17, Step 3.
d. Remove two screws holding front of cabinet
top to top front edge of control cabinet front.
Refer to Figure 19.
e. If area or space permits, lift cabinet top to a
vertical position by hinging it on the rear
hinges.
NOTE: To avoid damage to hinges, be sure to
support cabinet top with a small chain or something
similar. Refer to Figure 21.
f. Remove cabinet top from washer by removing
nuts and carriage bolts holding cabinet top and
hinges to control cabinet. Refer to Figure 20.
g. Carefully lift cabinet top off washer and set out
of the way to prevent damage.
h. Remove screws holding security top panel to
control cabinet front. Refer to Figure 21. Slide
security top panel back just far enough to
disengage tabs on panel from control cabinet
front and remove panel.
i. Remove screws holding control shield (with
controls attached) to bottom rear flange of
control cabinet wrapper.
j. Remove screws holding motor control board to
rear of control cabinet wrapper. Refer to
Figure 24.
k. Remove screws holding control cabinet
wrapper to top flange of side panels. Refer to
Figure 25.
l. Carefully lift control cabinet assembly off
washer and set out of the way.
800168 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING

49. LOWER ACCESS PANEL

a. While supporting the lower access panel,
remove two screws from bottom edge of lower
access panel. Refer to Figure 26.
b. Gently lower the access panel to disengage
panel locators from bottom edge of front panel.
Panel
Locators
Screws
Section 5 Service Procedures
Lower
Access Panel
H202SE1A
Figure 26
W003
95