Section 6 -Adjustments; Cabinet Leveling Legs - ALLIANCE HWF561*E1102 Service

To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
IMPORTANT: When reference is made to
directions (right or left) in this manual, it is from
operator's position facing front of washer.

63. CABINET LEVELING LEGS

a. Place washer in position on a clean, firm and
reasonably level floor. Installing the washer on
any type of carpeting is not recommended.
b. Loosen locknuts and adjust the leveling legs
until the washer does not rock. Refer to
Figure 45.
NOTE: Level must rest on raised portion of top
panel. Refer to Figure 45.
c. Tighten the locknuts securely against the
washer base. If the locknuts are not tight,
washer will move out of position during
operation.
CAUTION
DO NOT slide washer across floor if the
leveling legs have been extended, as legs
and base could become damaged.
CAUTION
Use of the dispenser drawer or washer door
as a handle in the transportation of the
washer may cause damage to the dispenser
or door.
d. Remove rubber feet from accessories bag and
place on all four leveling legs. Refer to
Figure 45.
800168
Section 6
Adjustments
W248
W185
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
WASHER
BASE
LOCKNUT
LEVELING
RUBBER
LEG
(3/8 INCH)
MODELS WITH THE LETTER "E" IN THE EIGHTH
CHARACTER OF THE MODEL NUMBER
WASHER
BASE
LEVELING
LEG
(1/2 INCH)
MODELS WITH THE LETTER "H" OR "J" IN THE
EIGHTH CHARACTER OF THE MODEL NUMBER
LEVEL
SPACER
FOOT
LEVEL
LOCKNUT
RUBBER
FOOT
Figure 45
W003
H216SE3A
119