ALLIANCE HWF561*E1102 Service page 126

Section 6 Adjustments
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
i. Check coin return pendulum to verify it
swings freely. If pendulum does not swing
freely, spray pendulum pivot point with
Teflon based lubricant and move pendulum
back and forth two to three times. An
additional application of Teflon based
lubricant may be necessary to ensure that
pendulum swings freely. Refer to Figure 52.
Pendulum
Figure 52
j. Check coin drop sensor for dust or dirt on
eyes. Wipe eyes with dry cotton swab. Refer
to Figure 53.
124
Pivot
Point
DRY6B
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
IMPORTANT: DO NOT use isopropyl alcohol to
clean electronic sensor or eyes.
Eyes
k. Reinstall coin return on to coin drop frame.
l. Reinstall metal clip and slide towards coin
insert slot. All cotter pin holes must line up.
m. Reinstall cotter pin.
n. Place drop on level surface to verify that coins
follow correct path in drop. It may be
necessary to lift drop to allow coin to follow
through sensor.
o. Reinstall coin drop into machine.
p. Reconnect electrical power to machine and
drop.
q. Add a coin to drop to verify that coin drop is
operating properly and that electrical
connection is working properly.
NOTE: If coin drop does not operate properly after
above steps have been completed, corrosion of metal
or vandalized components within coin drop may be
preventing the coin drop from functioning
correctly. Replace coin drop.
Cotton
Swab
DRY7B
Figure 53
W003
Dry
800168