ALLIANCE HWF561*E1102 Service page 20

Section 3 Troubleshooting
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
WORN BRUSH
– Has no visible brush
material remaining.
SERVICE PROCEDURE: CLOGGED BRUSHES
a. Remove motor from washer. Refer to Paragraph 58.
b. Using a flashlight, view brushes through holes in motor end shield. Refer to Figure 13.
c. Inspect both brushes to determine if they are clogged due to a build-up of carbon dust.
d. If there is a visible amount of brush left, use a screwdriver or similar device to push brush back and forth to
loosen and remove dust. Refer to Figure 13.
18
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
FLW1649S
FLW1649S
Figure 14
Brush
Holder
Brush spring
resting against
brush holder.
Brush
Spring
W003
800168