ALLIANCE HWF561*E1102 Service page 116

Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
j. Remove inner basket/trunnion assembly from
washer and evenly torque three nuts to 200 ± 10
inch-pounds.
k. Recheck that concentricity is still within .05
inch.
Dial Indicator
Outer
Tub
Figure 42
Inner Basket Installation –
a. Apply No. 27604P Anti-Seize Compound to
the area of the trunnion shaft that will be
contacting the front and rear bearings. Refer to
Figure 43.
b. Apply a film of grease to area of shaft that will
be contacting the bearing housing seal. Refer to
Figure 43. Make sure seal lips also are packed
with grease. Refer to Figure 43.
IMPORTANT: When installing inner basket, the
following steps must be taken to ensure that the seal
is properly orientated:
c. Install inner basket assembly by pushing all the
way into outer tub.
d. Install pulley, flat washer, lockwasher and left
hand cap screw. Refer to Figure 30.
114
FLW12K
Inner
Inner
Basket Lip
Basket
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
IMPORTANT: When installing pulley, always use a
new cap screw (included in kit) to prevent screw
from loosening during operation. Use a thread tap
to clean old Loctite out of pulley screw receiving
hole before installing new screw. This ensures that
inner basket and pulley properly seat.
e. Unscrew left hand thread screw half way.
f. Install pulley bolt tightening fixture between
the flat washer and the pulley. Refer to
Figure 44.
g. Tighten left hand thread screw until washer is
against pulley bolt tightening fixture.
h. Loosen screw about one half turn to free
fixture.
i. Remove pulley bolt tightening fixture.
j. From front of washer, pull inner basket forward
as far as possible. Flat washer should be against
pulley.
k. Push inner basket back into outer tub as far as
possible.
l. Tighten left hand thread screw. Be careful not
to push the trunnion shaft forward while
tightening the screw.
NOTE: Torque new left hand thread screw to 240
minimum to 260 maximum inch pounds (27.5 to
29.7 Nm).
W003
800168