Door Catch - ALLIANCE HWF561*E1102 Service

Section 6 Adjustments
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.

66. DOOR CATCH

NOTE: When repairing a broken or inoperative No.
685430 Door Catch, proceed as follows:
a. Remove door bezel.
b. Remove two screws and nuts holding door
catch to door and remove door catch.
c. Install new door catch and tighten screws and
nuts to the point of being snug.
685429
Door Lock
SHOWN CLOSED
122
Alignment of
These Two Edges
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
d. Adjust door catch so the outside edge is aligned
with the edge of the latch. Refer to Figure 48.
e. Visually check that the door catch properly
engages the funnel of the door latch/switch
assembly. Refer to Figure 48.
f. Recheck the alignment in step "d". Adjust if
needed.
g. Torque the two nuts to approximately 30 inch
pounds (3.4 Nm).
h. Reinstall door bezel.
Figure 48
W003
Funnel
Door
Catch
685430
Catch
H250SE3A
800168