Resetting To Factory Default And Clearing Data/Settings; Resetting The Settings Made Through The Web User Interface (Reset Web Settings) - Panasonic KX-UT670 Administrator's Manual

Section 9 Resetting the Unit
9.1 Resetting to Factory Default and Clearing Data/
Settings
When you reset the unit, all settings are returned their factory default status and all data is erased.
You can reset the unit in the following 2 ways.
•
Clear data and settings
All unit settings and the settings and registered data of applications are erased. However, applications are
not erased.
•
Reset to factory default
All data is erased. Applications, apart from pre-installed applications, are also erased.
1.
After starting the unit, press and hold the RESET button (A) with a pointy object until the screen is cleared.
A
2.
After the unit is restarted and **Reset Menu** is displayed, tap the key sheet in the following order:
®
3.
Tap or
Note
•
For details about the key sheet, refer to the Operating Instructions on the Panasonic Web site
(® see Introduction).
•
Data stored on the SD card is not erased.
•
If you tap [Cancel], the unit will start-up and the Home screen is displayed.
•
When the reset is complete, the unit will automatically restart.
9.2 Resetting the Settings Made through the Web
User Interface (Reset Web Settings)
Performing Reset Web Settings from the Web user interface (® see 4.8.3 Reset to Defaults) resets the
settings made through the Web user interface to their default values.
When you use this feature, the unit will return to the status just after performing the most recent provisioning
or pre-provisioning.
Notice
•
After performing Reset Web Settings, the unit will restart automatically. To avoid problems, it is
recommended that you save your settings before performing Reset Web Settings.
228 Administrator Guide
® ®
to select the resetting type, and then tap
®
.
Document Version 2012-07