Section 4 Web User Interface Programming
Flash Hook Event
Description
Value Range
Default Value
Configuration File Reference
Directed Call Pickup
Description
Value Range
Default Value
Configuration File Reference
4.7.1.2 Call Rejection Phone Numbers
1–30
Description
Value Range
Default Value
108
Administrator Guide
Specifies the type of signal sent when sending a flash hook event.
•
Signal
•
flashhook
Signal
FLASHHOOK_CONTENT_TYPE (Page 188)
Specifies the feature number assigned to a BLF for performing call
pickup.
Max. 4 characters
Not stored.
NUM_PLAN_PICKUP_DIRECT (Page 162)
Specifies the phone numbers to reject incoming calls from. A maximum
of 30 phone numbers can be specified.
Note
•
You can also configure this setting through the phone user
interface. If these settings are changed through the phone user
interface while being changed through the Web user interface,
the settings made through the phone user interface will be
overwritten by the settings made through the Web user
interface.
Max. 32 characters
Note
•
If the phone number contains characters other than 0–9, *, #,
and +, the number may not be rejected correctly.
Not stored.
Document Version 2012-07