Section 4 Web User Interface Programming
Default Value
Configuration File Reference
Conference Server URI
Description
Value Range
Default Value
Configuration File Reference
Inter-digit Timeout
Description
Value Range
Default Value
Configuration File Reference
Timer for Dial Plan
Description
Value Range
Default Value
Configuration File Reference
International Call Prefix
Description
Value Range
106
Administrator Guide
No
VM_SUBSCRIBE_ENABLE (Page 159)
Specifies the URI for a conference server, which consists of "sip:", a
user part, the "@" symbol, and a host part, for example,
"sip:conference@example.com".
Note
•
In a SIP URI, the user part ("conference" in the example above)
can contain up to 63 characters, and the host part
("example.com" in the example above) can contain up to 127
characters.
•
Availability depends on your phone system.
Max. 195 characters (except ", &, ', :, ;, <, >, and space)
Not stored.
CONFERENCE_SERVER_URI (Page 160)
Specifies the length of time, in seconds, within which subsequent digits
of a dial number must be dialed. When this timer expires after the last
key was pressed, dialing will start.
1–15
5
INTDIGIT_TIM (Page 160)
Specifies the length of time, in seconds, that the unit waits when a "T"
or "t" has been entered in the dial plan.
1–15
5
MACRODIGIT_TIM (Page 160)
Specifies the number to be shown in the place of the first "+" symbol
when the phone number for incoming international calls contains "+".
Max. 8 characters
Document Version 2012-07