Setup; Factory Defaults; Language Selection For The Unit; Basic Network Setup - Panasonic KX-UT670 Administrator's Manual

Section 1 Initial Setup

1.1 Setup

1.1.1 Factory Defaults

Many of the settings for this unit have been configured before the unit ships.
Where possible, these settings are configured with the optimum or most common values for the setting. For
example, the port number of the SIP (Session Initiation Protocol) server is set to "5060".
However, many of the settings, such as the address of the SIP server or the phone number, have not been
pre-configured, and they must be modified depending on the usage environment.

1.1.2 Language Selection for the Unit

You can change the language used on the display.
In addition, various settings can be configured by accessing the Web user interface from a PC on the same
network. You can select the language for the Web user interface.
Note
•
To select the display language for the unit, refer to the Operating Instructions on the Panasonic Web
site (® see Introduction).
•
To select the display language for the Web user interface, see 4.5.1 Web Language.

1.1.3 Basic Network Setup

This section describes the basic network settings that you must configure before you can use the unit on your
network.
You must configure the following network settings:
•
TCP/IP settings (DHCP [Dynamic Host Configuration Protocol] or static IP address assignment)
•
DNS server settings
•
Ethernet port settings (Ethernet port connection mode, LLDP settings or VLAN settings)
•
NTP server settings
Network Settings
The following procedures explain how to change the network settings via the unit.
For details about the individual network settings that can be configured via the unit, refer to the Operating
Instructions on the Panasonic Web site (® see Introduction).
For details about configuring network settings via the Web user interface, see 4.4.1 Basic Network
Settings.
To obtain an IP address from a DHCP server
1.
Press
2.
Tap [Network] and then select [Basic Network settings].
3.
In [Connection mode], select [DHCP].
4.
In [DHCP Settings], select [Receive DNS server address automatically].
5.
Tap [OK].
16 Administrator Guide
on the Home screen, and then tap [Settings].
Document Version 2012-07