Panasonic KX-UT136 User Manual
Hide thumbs
Also See for KX-UT136:
- Administrator's manual (312 pages) ,
- Administration manual (306 pages) ,
- Getting started (181 pages)
Related Manuals for Panasonic KX-UT136
Summary of Contents for Panasonic KX-UT136
- Page 1 Home PBXware SERVERware TELCOware SIPmon SIPProt Desktop & Mobile UADs Appliances From Bicom Systems Wiki...
- Page 2 This User Guide is written as general guide on how to set up Panasonic phone models: KX-HDV130 KX-UT113 KX-UT123 KX-UT133 KX-UT136 Contents 1 Supported Features...
-
Page 3: Supported Features
General UAD config Additional UAD configuration (per extension) Not supported Directory list Registering Phone This chapter describes how to register your Panasonic phone using manual configuration or auto provisioning. The following topics are covered: - Manual Configuration - Auto Provisioning... - Page 4 This chapter describes how to register Panasonic phone using Hostname or IP Address. NOTE: All Panasonic SIP Phones have web interface access disabled by default and in order to use it to setup your phone, it must be enabled from device itself. However, on each phone reboot this setting will turn off and in case administrator need to use web interface it will have to be enabled once more.
-
Page 5: Auto Provisioning
Please note, factory default login details are username: admin and password: adminpass. Klick VoIP tab and in left panel under SIP settings click Line 1 to set up first line on your Panasonic device to register to PBXware. REQUIRED FIELDS:... -
Page 6: Uad Settings
2. UAD settings Navigate to Settings -> UAD. Make sure corresponding Panasonic UAD is enabled. To check the UAD status click on the edit icon next to your Panasonic phone model. Make sure Status is set to Active, Auto provisioning is set to Yes, and DHCP is set to Yes. - Page 7 Embedded Web and press OK, select On and press OK. This should allow you to access your Panasonic settings on web interface. If there is no DHCP in your network, you can still auto provision your Panasonic phone. Please refer to your Panasonic User Guide for instruction about setting static IP address. After you...
-
Page 8: Tftp Provisioning
HTTP Provisioning HTTP Provisioning offers additional layer of security compared to TFTP so it is recommended to use it when provisioning Panasonic devices. NOTE: In order to use HTTP provisioning you must set up HTTP Username and HTTP password on PBXware. To do that, log in to your PBXware GUI and navigate to: HTTP Username and HTTP Password are set under: Settings ->... - Page 9 tftp://192.168.1.1/{mac}.cfg Replace 192.168.1.1 with your PBXware IP address or domain name and click Save to preserve changes and initiate auto provisioning. Once you click Save button your phone will reboot and send request for auto provisioning configuration file to PBXware. If all settings are configured properly phone should receive the configuration file and register to assigned extension once it boots up.