Section 5 Configuration File Programming
Description
Value Range
Default Value
FIRM_FILE_PATH
Value Format
Description
Value Range
Default Value
Web User Interface Reference
5.4.5 Provisioning Settings
OPTION66_ENABLE
Value Format
144
Administrator Guide
Specifies the firmware version of the unit.
Note
•
Changing this setting may require restarting the unit.
00.000–15.999
Empty string
String
Specifies the URL where the firmware file is stored.
Note
•
This setting is available only when
"FIRM_UPGRADE_ENABLE" is set to "Y".
•
Changing this setting may require restarting the unit.
Max. 500 characters
Note
•
The format must be RFC 1738 compliant, as follows:
"<scheme>://<user>:<password>@<host>:<port>/<url-path>".
–
"<user>" must be less than 128 characters.
–
"<password>" must be less than 128 characters.
–
"<user>:<password>@" may be empty.
–
The total of "<scheme>://" and "<host>:<port>/<url-path>"
must be less than 245 characters.
–
":<port>" can be omitted if you do not need to specify the
port number.
•
If "{mac}" is included in this URL, it will be replaced with the
unit's MAC address in lower-case.
•
If "{MAC}" is included in this URL, it will be replaced with the
unit's MAC address in upper-case.
•
If "{MODEL}" is included in this URL, it will be replaced with the
unit's model name.
•
If "{fwver}" is included in this URL, it will be replaced with
"FIRM_VERSION" depending on the system. Note that this rule
differs from other parameters such as "SIP_USER_AGENT".
Empty string
Firmware File URL (Page 122)
Boolean
Document Version 2012-07