Adjusting The Rear Wheel Static Balance; Installing The Rear Wheel - Yamaha 2008 Fazer FZ1-N Service Manual

4. Check:
• Check the clearance "a" between the rear
wheel sensor and sensor rotor.
Out of specification → Check the exist-
ence of foreign matters in the wheel sen-
sor attaching section, remove if any, and
perform the installation.
Rear wheel sensor and sensor
rotor clearance
1.0–1.6 mm (0.039–0.063 in)
Thickness gauge
5. Install:
• Rear wheel sensor lead stay
• Rear wheel sensor lead holder "3"
• Clamp "4"
6. Connect:
• Rear wheel sensor coupler "5"
ECA14500
CAUTION:
To route the rear wheel sensor lead, refer to
"CABLE ROUTING" on page 2-41.
7. Check:
• Rear wheel sensor installation
Check if the wheel sensor housing is
installed properly.
EAS22150
ADJUSTING THE REAR WHEEL STATIC
BALANCE
NOTE:
• After replacing the tire, wheel or both, the
rear wheel static balance should be adjusted.
• Adjust the rear wheel static balance with the
brake disc and rear wheel drive hub installed.
1. Adjust:
• Rear wheel static balance
Refer to "ADJUSTING THE FRONT
WHEEL STATIC BALANCE" on page 4-
14.
EAS22160

INSTALLING THE REAR WHEEL

1. Lubricate:
• Wheel axle
• Wheel bearings
• Oil seal lips
Recommended lubricant
Lithium-soap-based grease
2. Adjust:
• Drive chain slack
Refer to "ADJUSTING THE DRIVE
CHAIN SLACK" on page 3-27.
Drive chain slack
25.0–35.0 mm (0.98–1.38 in)
3. Tighten:
4-24
REAR WHEEL