Yamaha 2008 Fazer FZ1-N Service Manual page 16

3. LCD
4. Brightness level
This function allows you to adjust the bright-
ness of the LCD and the tachometer panel and
needle to suit the outside lighting conditions.
To set the brightness
1. Turn the key to "OFF".
2. Push and hold the "SELECT" button.
EAS5D01001
OUTLINE OF THE ABS
1. The Yamaha ABS (anti-lock brake system) features a dual electronic control system, which acts
on the front and rear brakes independently.
2. The ABS features a compact and lightweight design to help maintain the basic maneuverability
of the vehicle.
3. The hydraulic unit, which is the main component of the ABS, is centrally located on the vehicle to
increase mass centralization.
ABS layout
1. ABS warning light
2. ABS ECU (electronic control unit)
3. ABS motor relay
4. Hydraulic unit (HU)
5. Rear brake caliper
6. Rear wheel sensor
7. Rear wheel sensor rotor
ABS
The operation of the Yamaha ABS brakes is the same as conventional brakes on other vehicles, with
a brake lever for operating the front brake and a brake pedal for operating the rear brake.
When wheel lock is detected during emergency braking, hydraulic control is performed by the
hydraulic system on the front and rear brakes independently.
3. Turn the key to "ON", and then release the
"SELECT" button after five seconds.
4. Push the "RESET" button to select the
desired brightness level.
5. Push the "SELECT" button to confirm the
selected brightness level. The display will
return to the odometer or tripmeter mode.
8. Front brake caliper
9. Front wheel sensor
10.Front wheel sensor rotor
A. FZ1-NA
B. FZ1-SA
1-7
FEATURES