Removing The Lower Bracket; Checking The Steering Head - Yamaha 2008 Fazer FZ1-N Service Manual

EAS23110

REMOVING THE LOWER BRACKET

1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there
is no danger of it falling over.
2. Remove:
• Upper ring nut "1"
• Rubber washer
• Lower ring nut "2"
• Lower bracket
NOTE:
Hold the lower ring nut with the ring nut wrench
"3", and then remove the upper ring nut with
the steering nut wrench "4".
Ring nut wrench
90890-01268
Spanner wrench
YU-01268
Steering nut wrench
90890-01403
Spanner wrench
YU-33975
EWA13730
WARNING
Securely support the lower bracket so that
there is no danger of it falling.
EAS23120

CHECKING THE STEERING HEAD

1. Wash:
• Bearings
• Bearing races
Recommended cleaning solvent
Kerosene
2. Check:
• Bearings "1"
• Bearing races "2"
Damage/pitting → Replace.
3. Replace:
• Bearings
• Bearing races
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the bearing races from the steer-
ing head pipe with a long rod "1" and ham-
mer.
b. Remove the bearing race from the lower
bracket with a floor chisel "2" and hammer.
c. Install a new rubber seal and new bearing
races.
ECA14270
CAUTION:
If the bearing race is not installed properly,
the steering head pipe could be damaged.
NOTE:
• Always replace the bearings and bearing
races as a set.
• Whenever the steering head is disassem-
bled, replace the rubber seal.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
4-73
STEERING HEAD