Yamaha 2008 Fazer FZ1-N Service Manual page 115

FZ1-S(X)
1. Clutch cable
2. Left handlebar switch lead
3. Immobilizer lead
4. Main switch lead
5. Protector
6. Throttle cables
7. Right handlebar switch lead
8. Throttle cable (pull side)
9. Throttle cable (return side)
10.Bracket
11.Wire harness
12.Turn signal light lead
13.Seat lock cable
14.Tail/brake light lead
15.Battery box
16.Mud guard
17.Fender
18.Frame
19.Cover
A. Positioning tape (shaded area)
B. Secure the wire harness to the bracket.
Position the clamp head on the upper side
of the vehicle and point the tip to the front
side of the vehicle.
C. Attach the clamp to the front upper cowl-
ing. Clamp the turn signal light lead (left)
and headlight lead.
D. Pass the turn signal light lead (left) and tail/
brake light lead under the rear fender
bracket.
E. Pass the turn signal light lead (left) and tail/
brake light lead the route between the ribs
of the battery box.
F. Clamp each lead at the positioning taping
section and then insert it to the cover. (In
random order) Positioning tape is only
used for the right handlebar switch. Fit
other leads so that they are not slack.
G. Clamp each lead at the positioning taping
section and then insert it to the cover. (In
random order) Route the rear side of the
vehicle to the wire harness.
2-70
CABLE ROUTING