Yamaha 2008 Fazer FZ1-N Service Manual page 508

Checking the condition of the bulb sockets
The following procedure applies to all of the
bulb sockets.
1. Check:
• Bulb socket (for continuity)
(with the pocket tester)
No continuity → Replace.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
NOTE:
Check each bulb socket for continuity in the
same manner as described in the bulb section;
however, note the following.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Install a good bulb into the bulb socket.
b. Connect the pocket tester probes to the
respective leads of the bulb socket.
c. Check the bulb socket for continuity. If any
of the readings indicate no continuity,
replace the bulb socket.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS28000
CHECKING THE FUSES
The following procedure applies to all of the
fuses.
ECA13680
CAUTION:
To avoid a short circuit, always set the main
switch to "OFF" when checking or replac-
ing a fuse.
1. Remove:
• Rider and passenger seat
2. Check:
• Fuse
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Connect the pocket tester to the fuse and
check the continuity.
ELECTRICAL COMPONENTS
NOTE:
Set the pocket tester selector to "Ω × 1".
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
b. If the pocket tester indicates "∞", replace
the fuse.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
3. Replace:
• Blown fuse
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Set the main switch to "OFF".
b. Install a new fuse of the correct amperage
rating.
c. Set on the switches to verify if the electrical
circuit is operational.
d. If the fuse immediately blows again, check
the electrical circuit.
Fuses
Main
Headlight (FZ1-N(X),
FZ1-SA)
Headlight (FZ1-S(X),
FZ1-SA)
Signaling system
Tail/brake light
Ignition
ABS motor (FZ1-SA,
FZ1-NA)
ABS control unit (FZ1-
SA, FZ1-NA)
Backup
Radiator fan motor
Reserve
Reserve (FZ1-N)
Reserve (FZ1-S(X),
FZ1-SA))
Reserve (FZ1-SA))
8-139
Amperage
Q'ty
rating
50 A 1
15 A 1
25 A 1
10 A 1
10 A 1
15 A 1
30 A 1
10 A 1
10 A 1
10 A 2
10 A 1
15 A 1
25 A 1
30 A 1