Yamaha 2008 Fazer FZ1-N Service Manual page 489

1. ABS ECU
2. Red
3. Red
4. Red
*Continuity between: "A"–"B", "A"–"C", "D"–"G", "E"–"F"
• Check the insulation of the hydraulic unit solenoid circuits and the negative battery terminal.
4. Battery
• Battery terminal is disconnected
Malfunction code 22 (Starter motor monitor malfunction)
1. Disconnection of the wire harness for the start system circuit
→ Check the conductivity of the wire harness and repair or replace the failure part.
2. Disconnection of the starter motor monitor
→ Check the conductivity of the wire harness and repair or replace the failure part.
1. Starter relay
2. Blue/White
*Continuity between: "A"–"B"
NOTE:
If you do not start the engine with the starter switch but repeat push-starting the engine excessively,
this code may be input.
Malfunction code 24 (Step light failure [Brake system circuit has failure].)
1. Disconnection of the wire harness for the brake circuit
→ Check the conductivity of the wire harness and repair or replace the failure part.
2. Disconnection of the stop lamp monitor
→ Check the conductivity of the wire harness and repair or replace the failure part.
ABS (ANTI-LOCK BRAKE SYSTEM)
5. Front solenoid
6. Rear solenoid
7. Green
8. White/Red
3. ABS ECU
8-120