Removing The Rear Brake Master Cylinder; Checking The Rear Brake Master Cylinder; Assembling The Rear Brake Master Cylinder; Installing The Rear Brake Master Cylinder - Yamaha 2008 Fazer FZ1-N Service Manual

2008 motorcycle
Hide thumbs Also See for 2008 Fazer FZ1-N:
Table of Contents

Advertisement

7. Check:
• Brake pedal operation
Soft or spongy feeling → Bleed the brake
system.
Refer to "BLEEDING THE HYDRAULIC
BRAKE SYSTEM" on page 3-25.
EAS22700
REMOVING THE REAR BRAKE MASTER
CYLINDER
1. Remove:
• Union bolt "1"
• Copper washers "2"
• Brake hose "3"
NOTE:
To collect any remaining brake fluid, place a
container under the master cylinder and the
end of the brake hose.
EAS22720
CHECKING THE REAR BRAKE MASTER
CYLINDER
1. Check:
• Brake master cylinder
Damage/scratches/wear → Replace.
• Brake fluid delivery passages
(brake master cylinder body)
Obstruction → Blow out with compressed
air.
2. Check:
• Brake master cylinder kit
Damage/scratches/wear → Replace.
3. Check:
• Brake fluid reservoir
Cracks/damage → Replace.
• Brake fluid reservoir diaphragm
Cracks/damage → Replace.
4. Check:
• Brake hose
Cracks/damage/wear → Replace.
EAS22730
ASSEMBLING THE REAR BRAKE MASTER
CYLINDER
EWA13520
WARNING
• Before installation, all internal brake com-
ponents should be cleaned and lubricated
with clean or new brake fluid.
• Never use solvents on internal brake
components.
Recommended brake fluid
DOT4
EAS22740
INSTALLING THE REAR BRAKE MASTER
CYLINDER
1. Install:
• Copper washers
• Brake hose "1"
• Union bolt "2"
Brake hose union bolt
30 Nm (3.0 m·kg, 22 ft·lb)
EWA5D01006
WARNING
Proper brake hose routing is essential to
insure safe vehicle operation.
Refer to "CABLE ROUTING" on page 2-41.
ECA5D01013
CAUTION:
When installing the brake hose onto the
brake master cylinder, make sure the brake
pipe touches the projection "a" as shown.
4-48
REAR BRAKE
New

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents