Yamaha 2008 Fazer FZ1-N Service Manual page 219

A. FZ1-SA
B. FZ1-NA
6. Set the engine stop switch to "
7. Set the main switch to "ON".
NOTE:
After setting the main switch to "ON", wait
(approximately 2 seconds) until the ABS warn-
ing light goes off.
8. Push the start switch for at least 4 seconds.
ECA14790
CAUTION:
Do not operate the brake lever or the brake
pedal.
9. After releasing the start switch, operate the
brake lever and the brake pedal simulta-
neously.
NOTE:
• A reaction-force pulsating action is gener-
ated in the brake lever "1" 0.5 second after
the brake lever and the brake pedal are oper-
ated simultaneously and continues for
approximately 1 second.
• Be sure to continue to operate the brake
lever and brake pedal even after the pulsat-
ing action has stopped.
ABS (ANTI-LOCK BRAKE SYSTEM)
10. After the pulsating action has stopped in
the brake lever, it is generated in the brake
pedal "2" 0.5 second after and continues
for approximately 1 second.
".
NOTE:
Be sure to continue to operate the brake lever
and brake pedal even after the pulsating action
has stopped.
11. After the pulsating action has stopped in
the brake pedal, it is generated in the brake
lever 0.5 second after and continues for
approximately 1 second.
ECA14800
CAUTION:
• Check that the pulsating action is felt in
the brake lever, brake pedal, and again in
the brake lever, respectively.
• If the pulsating action is felt in the brake
pedal before it is felt in the brake lever,
check that the brake hoses are connected
correctly to the hydraulic unit.
4-56