Adjusting The Rear Wheel Static Balance; Installing The Rear Wheel (Disc Brake) - Yamaha TMAX XP500F 2015 Service Manual

▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
2. Lubricate:
• Oil seal lips
Recommended lubricant
Lithium-soap-based grease
EAS30164
ADJUSTING THE REAR WHEEL STATIC
BALANCE
TIP
• After replacing the tire, wheel or both, the rear
wheel static balance should be adjusted.
• Adjust the rear wheel static balance with the
brake disc and rear wheel pulley installed.
1. Adjust:
• Rear wheel static balance
Refer to "ADJUSTING THE FRONT WHEEL
STATIC BALANCE" on page 4-27.
EAS30165
INSTALLING THE REAR WHEEL (DISC
BRAKE)
1. Install:
• Rear brake disc
Rear brake disc bolt
30 Nm (3.0 m·kgf, 22 ft·lbf)
LOCTITE®
ECA19150
NOTICE
Replace the brake disc bolts with new ones.
TIP
Tighten the brake disc bolts in stages and in a
crisscross pattern.
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
4-37
2. Check:
• Rear brake disc
Refer to "CHECKING THE REAR BRAKE
DISC" on page 4-62.
3. Install:
• Drive belt guide
• Rear wheel pulley
Rear wheel pulley bolt
64 Nm (6.4 m·kgf, 46 ft·lbf)
LOCTITE®
Drive belt guide bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
LOCTITE®
TIP
• Tighten the rear wheel pulley bolts in stages
and in a crisscross pattern.
• When tightening the drive belt guide bolts,
tighten the bolt at the punch mark "a" first and
then other bolts in stages and in a crisscross
pattern.
REAR WHEEL