Yamaha 2008 Fazer FZ1-N Service Manual page 497

EAS5D01005
[D-6-4] DELETING THE MALFUNCTION CODE
1. Connect the test coupler adapter "1" to the test coupler "2". Refer to "[B-5] MALFUNCTION
CHECK BY THE ABS SELF DIAGNOSIS (PRESENT MALFUNCTION)"
A. FZ1-SA
B. FZ1-NA
2. Turn the main switch on.
• The multi-function display indicates previously recorded malfunction codes.
NOTE:
The ABS error code is not displayed during the diagnosis of the fuel injection.
3. Turn the engine stop switch off.
ECA4S81019
CAUTION:
If the starter switch is pushed without turning the engine stop switch off, it may damage the
starting motor gears or other parts, therefore be sure to turn it off.
4. Push the starter switch more than 10 times in 4 seconds to delete the malfunction codes.
NOTE:
If the malfunction codes cannot be cleared, the disconnection of the starter switch monitor leads
could be a cause.
5. Turn the main switch off.
6. Turn the main switch on again.
• Check that the ABS warning light goes on for 2 seconds, then goes out for 3 seconds and
starts flashing.
ABS (ANTI-LOCK BRAKE SYSTEM)
8-128