Yamaha 2008 Fazer FZ1-N Service Manual page 107

FZ1-SA
1. Throttle cables
2. Right handlebar switch lead
3. Throttle cable (pull side)
4. Throttle cable (return side)
5. Coolant reservoir tank hose
6. Radiator inlet hose
7. Air filter drain hose
8. AC magneto lead
9. Direct ignition coil lead coupler
10.Engine ground lead
11.Neutral switch lead
12.Rear brake light switch lead
13.EXUP cable
14.EXUP servo motor
15.Rear frame ground lead
16.Main fuse
17.Atmospheric pressure sensor
18.Battery positive lead
19.Radiator fan motor relay
20.Starting circuit cut-off relay
21.Fuse box
22.Lean angle sensor
23.Turn signal light lead (right)
24.License plate light lead
25.Turn signal relay
26.Turn signal light lead (left)
27.Seat lock cable
28.Turn signal light lead coupler (left)
29.Starter relay
30.ABS motor coupler
31.Rear wheel sensor lead
32.Fuel tank breather hose
33.Battery negative lead
34.Starter motor lead
35.Coolant reservoir tank drain hose
36.Fuel hose bend R section
37.Idle adjust screw wire
38.Throttle body lead
39.Air cut-off valve hose
40.ECU (engine control unit)
41.Water pump breather hose
42.Wire harness
43.Clutch cable
44.Left handlebar switch lead
45.Immobilizer lead
46.Main switch lead
47.Velcro
48.Frame
49.Cover
50.Direct ignition coil lead
51.Fuel hose
52.Immobilizer anti-theft alarm coupler
53.Radiator fan motor lead (left)
54.Oil level switch lead
55.O sensor lead
2
56.Sidestand switch lead
57.Speed sensor lead
58.Radiator fan motor lead (Right)
59.Rear frame
60.Battery box
61.Battery
62.Turn signal light relay lead
63.ABS fuse lead
64.Lean angle sensor lead
65.Mad guard
66.Fender
67.Tail/brake light lead
68.Headlight leads
69.Rectifier/regulator lead
70.AC magneto lead
71.Stay
72.Front upper body
73.Cap nut
74.Alarm lead
75.Ground lead
A. To the direct ignition coil lead
B. Make sure to install the air filter after
checking that the leads are positioned out-
side of the vehicle from the throttle body
side cover.
C. Direct ignition coil lead protector edge
D. Bind the left handle bar switch leads, main
switch leads, right handle bar switch leads,
immobilizer leads, front wheel sensor lead,
radiator fan motor leads (right), wire har-
ness and direct ignition leads (in random
order). Make sure to set the clamping posi-
tion to be ahead of the immobilizer anti-
safety alarm coupler and rear brake switch
leads branch position, and to be within a
range of 0 to 30 mm (0 to 1.18 in) away
from the protector end of the direct ignition
coil lead. Install the band pointing its tip
end downward inside the vehicle.
E. Route the pickup coil lead below the fuel
hose, throttle body hoses and air filter drain
hose.
F. 0–30 mm (0–1.18 in)
G. Route the wire harness below the clutch
cable.
H. Insert the wire harness wrapping clamp to
the hole of the frame.
I. To the rear brake light switch
J. Open to the air
K. Insert the main fuse to the battery band.
Soapy water can be spread.
L. Route the battery positive lead under the
relays.
2-62
CABLE ROUTING