Removing The Handlebar; Checking The Handlebar; Installing The Handlebar - Yamaha 2008 Fazer FZ1-N Service Manual

2008 motorcycle
Hide thumbs Also See for 2008 Fazer FZ1-N:
Table of Contents

Advertisement

EAS22860

REMOVING THE HANDLEBAR

1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there
is no danger of it falling over.
2. Remove:
• Handlebar grip "1"
NOTE:
Blow compressed air between the handlebar
and the handlebar grip, and gradually push the
grip off the handlebar.
3. Remove:
• Throttle cable housing "1"
• Throttle grip "2"
NOTE:
While removing the throttle cable housing, pull
back the rubber cover "3".
EAS22880

CHECKING THE HANDLEBAR

1. Check:
• Handlebar
Bends/cracks/damage → Replace.
EWA13690
WARNING
Do not attempt to straighten a bent handle-
bar as this may dangerously weaken it.
EAS22930

INSTALLING THE HANDLEBAR

1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there
is no danger of it falling over.
2. Install:
• Lower handlebar holders "1"
NOTE:
Temporarily tighten the nuts "2".
3. Install:
• Handlebar "1"
• Upper handlebar holder "2"
Upper handlebar holder bolt
24 Nm (2.4 m·kg, 17 ft·lb)
ECA14250
CAUTION:
• First, tighten the bolts on the front side of
the handlebar holder, and then on the rear
side.
• Turn the handlebar all the way to the left
and right. If there is any contact with the
fuel tank, adjust the handlebar position.
NOTE:
• The upper handlebar holder should be
installed with the punch mark "a" facing for-
ward.
• Align the match marks "b" on the handlebar
with the upper surface of the lower handlebar
holders.
4-59
HANDLEBAR

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents