Yamaha 2008 Fazer FZ1-N Service Manual page 89

FZ1-N(X)/FZ1-S(X)
1. Wire harness
2. Right handlebar switch lead
3. Throttle cable
4. Radiator inlet hose
5. Wire guide
6. Brake fluid reservoir hose
7. Fuel tank breather hose
8. EXUP cable wire bending attachment
9. EXUP cables
10.Rear brake light switch lead
11.Radiator fan motor lead (right)
12.Coolant reservoir tank hose
13.Brake hose
14.Clutch cable
15.Radiator stay
16.Throttle cable (return side)
17.Throttle cable (pull side)
18.Frame
19.Rear brake light switch stay
20.Footrest bracket (right)
21.Rear brake light switch
A. Wire is connected to the meter.
B. 5 mm (0.20 in)
C. Clamp the brake hose to the stay assem-
bly. Clamping position should be 5 mm
(0.20 in) or more away and less than 10
mm (0.39 in) from the top end of the brake
hose protector. Point the clamp head to the
outside of the vehicle and cut the tip of the
clamp head leaving 2 to 4 mm (0.08 to 0.16
in).
D. 10 mm (0.39 in)
E. To the throttle bodies
F. Clamp the coolant reservoir hose and radi-
ator inlet hose. Point the clamp opening to
the outside of the vehicle and the tip of the
clamp to the front upper side of the vehicle,
and pay attention so that the tip does not
protrude from the radiator cover. (FZ1-
N(X))
G. Route the fuel tank breather hose by the
wire guide. The white paint position of the
hose shall be lower than the wire guide.
H. To the EXUP
I. Pass the fuel tank breather hose and
EXUP cable through the wire guide of the
rear brake light switch stay.
J. The clamp position shall be at the center of
bending section of the brake fluid reservoir
hose as shown in the illustration.
K. Bind the two EXUP cables with the clamp.
For the clamping position, a part of the
clamp should be located within a range of
10 mm (0.39 in) from the end of wire bend-
ing attachment. Any direction of the clamp
opening can be accepted.
L. 0–10 mm (0.39 in)
M. To the wire harness
N. To the coolant reservoir tank
O. Route the radiator fan motor lead (right) so
that there is no slack as much as possible
in this section.
P. Pass the radiator fan motor lead (right)
above the coolant reservoir hose and route
it to the inside of the frame.
Q. Pass the coolant reservoir hose to the vehi-
cle inner side of the radiator inlet hose and
route it to the lower outside of the vehicle of
the thermostat assembly.
R. To the headlight
S. Route in the concavity section of the radia-
tor stay.
T. Route the wire guide of the radiator stay as
shown in the illustration. (Twisting not
allowed)
U. The outside of the vehicle.
V. The inside of the vehicle.
W. The front side of the vehicle.
X. Point the clamp head to the outside of the
vehicle and fit it so that the band tip is posi-
tioned at the vehicle front side.
Y. Pass the fuel tank breather hose through
the guide wire of the sidestand bracket.
Make sure to place the white paint position
of the hose lower than the guide wire.
2-44
CABLE ROUTING