Tadiran Telecom Emerald ICE Installation Manual page 78

5-2
Emerald ICE Installation & Hardware Reference Manual
5.Power up the KSU again.
6.Verify that the telephones have been initialized. A date and time display will
be visible on the Deluxe telephones. For a Standard telephone, a dial tone
will be heard.
Date & Time Display
Deluxe Telephone
7.Enter the RMP programming mode. Select RM, Remote Control and perform
a Software Cold Start.
8.It should be approximately 30 seconds before a display is visible on the
Deluxe Telephones or a Dial Tone is heard on a Standard Telephone.
9.When a display is visible on the Deluxe Telephones or a Dial Tone is heard
on a Standard Telephone, power down the KSU, wait 15 seconds, and then
power up the KSU again.
Dial Tone
Standard Telephone