System Bring-Up; Configuring Network Attributes; Figure 14: Two Power Inlets - Electric Caution Notifications; Table 8: Serial Terminal Program Configuration - Mellanox Technologies TX6000 Hardware User Manual

Caution: After inserting a power cable and confirming the green System Status LED
light is on, make sure that the Fan Status LED shows green.
If the Fan Status LED is not green, unplug the power connection and check that the
fan module is inserted properly and that the mating connector of the fan unit is free of
any dirt and/or obstacles. If no obstacles were found and the problem persists, call
your Mellanox representative for assistance.
CAUTION
Risk of electric shock and energy
hazard. The two power supply
units are independent.
Disconnect all power supplies to
ensure a powered down state
inside of the switch platform.
2.8

System Bring-Up

2.8.1

Configuring Network Attributes

The procedures described in this chapter assume that you have already installed and powered-on
according to the instructions in this document.
 To perform initial configuration of the system, perform the following:
Connect a host PC to the Console RJ45
Step 1.
cable (DB9 to RJ45). Make sure to connect to the Console RJ45 port and not to the (Ethernet)
MGT port.
Configure a serial terminal program (for example, HyperTerminal, minicom, or Tera Term) on
Step 2.
your host PC with the settings described in
CLI prompt of the system.
Table 8 - Serial Terminal Program Configuration
Baud Rate
Data bits
Stop bits
Parity

Figure 14: Two Power Inlets - Electric Caution Notifications

Gafahr des elektrischen
Schocks. Entferrnen des
Netzsteckers elnes Netz-
teils spannungsfrei. Um
alle Einhieten spannungs-
frei zu machen sind die
Netzstecker aller Netzteile
zu entfernen
Parameter
9600
8
1
None
ACHTUNG
Risque de choc et de danger
e'lectriques. Le de'branch-
ment d'une seule alimentation
stabilise'e ne de'branch
uniquement qu'un module
"Alimentation Stabilise'e".
Pour isoler completement le
module en cause, Il faut
de'brancher toutes les alimen-
tations stabilise'es.
port of the system using the supplied harness
Table 8. Once you perform that, you should get the
Setting
ATTENTION
Mellanox Technologies 20