Figure 7: Connect Rail Slide To Rack Vertical Support; Figure 8: Inserting The Caged Nuts For The Faceplate - Mellanox Technologies MSX6512-4R. Hardware Installation Manual

InfiniBand FDR Switch Platform Hardware User Manual
6. Place the four bolts for the caged nuts within reach.
7. Put the shelf into place and screw the bolts into the nuts from step 3
8. Extend the rail slides to the rack vertical support and screw them to the rack using the
2 hole washers and lock washers. See Figure 7.
9. Tighten all of the screws to 7.7 Nm or 68 pound inches.
10. Insert 8 caged nuts for the faceplate in the exact locations shown in
Figure 8,"Inserting the Caged Nuts for the Faceplate".
11. Install the filler panel directly below the shelf.
9
8
7
6
5
4
3
2
1
Shelf
Filler panel
Mellanox Technologies

Figure 7: Connect Rail Slide to Rack Vertical support

Figure 8: Inserting the Caged Nuts for the Faceplate

Spine Side
Place the
caged nuts here.
9
Leaf Side
8
7
6
5
4
Place the caged
nuts here.
3
2
1
Shelf
24