InfiniBand Switch Platform Hardware User Manual
3.1
Power Supply and Spine Board Indicator Status at Power ON
As the power is turned on, you should observe the following conditions for normal oper-
ation:
1. Power Supply Unit(s) AC OK and DC OK indicators are ON and FAIL indicators are
OFF.
2. There is a green Status LED per spine board, per leaf board, and per management
module that indicates power supplies are good.
3. Spine Board indicators will display status of internal links to the installed leaf boards.
All PHY links to existing leaf Boards should be ON.
4. Check the Spine LEDs and make sure they coincide with Figure 56.
5. Check the Management Module LEDs and make sure they coincide with Figure 57.
Figure 57: Management Module Status Indications for Normal Operation
Mellanox Technologies
It can take up to 5 minutes to boot up the system. Turn off the system if any LEDs
remain red for more than 5 minutes.
Figure 56: Spine Side Panel Display Status Indications
I2C
CONSOLE
MGT
RST
PSU
S.FANS
L.FANS
Master
MAC
66