Leaf Package Contents; Spine Package Contents; Management Package Contents; Physical Installation - Mellanox Technologies MSX6512-4R. Hardware Installation Manual

216-port infiniband fdr switchx switch platform
Hide thumbs Also See for MSX6512-4R.:
Table of Contents

Advertisement

InfiniBand FDR Switch Platform Hardware User Manual
• 1 cable management kit
Before you install your new SX6512 series chassis, unpack the system and check to
make sure that all the parts have been sent, check this against the parts list. Check the
parts for visible damage that may have occurred during shipping.
1.4

Leaf Package Contents

The leafs are ordered by the customer and are shipped 4 to a box. The customer will
receive as many boxes as needed to fill the order.
1.5

Spine Package Contents

The spines are shipped 3 to a box. The customer will receive as many boxes as needed to
fill the chassis with a full complement of spines.
1.6

Management Package Contents

The package includes:
• all of the management modules ordered by the customer
• 1 RJ45 to DB9 harness for each management module received
1.7

Physical Installation

The switch platform uses 10U of rack space in a standard 19" rack, 9U for the chassis
and 1U for the shelf. The switch ships from the factory with mounting holes on the spine
side. There are upper brackets to connect the leaf side to the rack near the top of the chas-
Mellanox Technologies
If anything is damaged or missing, contact your customer representative immediately.
The rack mounting holes conform to the EIA-310 standard for 19-inch racks. Guaran-
tee proper ventilation, by leaving 8cm (3") of space to the front and rear of the switch.
This will ensure proper air flow through the chassis. This is crucial for maintaining
good airflow at ambient temperature. In particular, route cables such that they do not
impede the air into or out of the chassis.
Insert the bottom spine board first.
Warning: This equipment is very heavy. Safety is the first concern. Make sure that
adequate manpower and proper equipment is used for transporting and moving the
chassis.
The fully loaded chassis weighs:
120 kg (265 LBS) full configuration
48 KG (105 LBS) empty configuration
83.94kg (185 LBS) shipped configuration
17

Advertisement

Table of Contents
loading

This manual is also suitable for:

Msx6512-nr

Table of Contents