Figure 7: Connect Rail Slide To Rack Vertical Support - Mellanox Technologies MIS5200Q-4DNC Hardware Installation Manual

216-port infiniband qdr switchx switch platform
Hide thumbs Also See for MIS5200Q-4DNC:
Table of Contents

Advertisement

InfiniBand Switch Platform Hardware User Manual
6. Place the four bolts for the caged nuts within reach.
7. Put the shelf into place and screw the bolts into the nuts from step 3
8. Extend the rail slides to the rack vertical support and screw them to the rack using the
2 hole washers and lock washers. See Figure 7.
9. Tighten all of the screws to 7.7 Nm or 68 pound inches.
10. Insert 8 caged nuts for the faceplate in the exact locations shown in
Figure 8,"Inserting the Caged Nuts for the FaceplateChassis on Shelf with Filler
Panel".
11. Install the filler panel directly below the shelf.
Mellanox Technologies

Figure 7: Connect Rail Slide to Rack Vertical support

23

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mis5100q-3dnc

Table of Contents