Figure 25 Menu 11.8 - Advance Setup Options; Table 14 Menu 11.8 Advance Setup Options - Nortel BCM50a Configuration Manual

Move the cursor to the Edit Advance Options field, press [SPACE BAR] to
select Yes, then press [ENTER] to display Menu 11.8 – Advance Setup
Options.
Figure 25 Menu 11.8 – Advance Setup Options
Menu 11.8 - Advance Setup Options
PPPoE pass-through = No
Press ENTER to Confirm or ESC to Cancel:
Table 14 describes the fields in

Table 14 Menu 11.8 Advance Setup Options

Field
PPPoE pass-through Press [SPACE BAR] to select Yes and press [ENTER] to enable
After you complete this menu, press [ENTER] at the prompt "Press ENTER to Confirm..."
to save your configuration, or press [ESC] at any time to cancel.
Figure 25.
Description
PPPoE pass through. In addition to the Contivity 251's built-in
PPPoE client, you can enable PPPoE pass through to allow up to
ten hosts on the LAN to use PPPoE client software on their
computers to connect to the ISP via the Contivity 251. Each host
can have a separate account and a public WAN IP address.
PPPoE pass through is an alternative to NAT for application where
NAT is not appropriate.
Press [SPACE BAR] to select No and press [ENTER] to disable
PPPoE pass through if you do not need to allow hosts on the LAN
to use PPPoE client software on their computers to connect to the
ISP.
BCM50a Integrated Router Configuration — Advanced
Chapter 6 Remote Node setup 81