Table of Contents
Advertisement
170 Chapter 15 Firmware and configuration file maintenance
Figure 84 Telnet Into Menu 24.7.1 Upload System Firmware
To upload the system firmware, follow the procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your system. Then type "nnadmin" and
3. Type "put firmwarefilename ras" where "firmwarefilename" is the name
4. The system reboots automatically after a successful firmware upload.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on uploading system firmware using TFTP (note
that you must remain on this menu to upload system firmware using TFTP),
please see your manual.
Configuration file upload
The screen shown in
Figure 85 Telnet Into Menu 24.7.2 System Maintenance
Menu 24.7.2 - System Maintenance - Upload System Configuration File
To upload the system configuration file, follow the procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your system. Then type "nnadmin" and
3. Type "put configurationfilename rom-0" where "configurationfilename"
which
4. The system reboots automatically after the upload system configuration
For details on FTP commands, please consult the documentation of your FTP
client program. For details on uploading system firmware using TFTP (note
that you must remain on this menu to upload system firmware using TFTP),
please see your manual.
N0115791
Menu 24.7.1 - System Maintenance - Upload System Firmware
SMT password as requested.
of your firmware upgrade file on your workstation and "ras" is the
remote file name on the system.
Press ENTER to Exit:
Figure 85
SMT password as requested.
is the name of your system configuration file on your workstation,
will be transferred to the "rom-0" file on the system.
file process is complete.
Press ENTER to Exit:
appears when you access menu 24.7.2 via Telnet.
Advertisement
Chapters
Table of Contents
