Restore Using Ftp Session Example; Uploading Firmware And Configuration Files; Firmware File Upload; Figure 83 Restore Using Ftp Session Example - Nortel BCM50a Configuration Manual

Restore using FTP session example

Figure 83 Restore using FTP session example

ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit
Refer to
configurations that disallow TFTP and FTP over WAN.

Uploading Firmware and Configuration Files

This section shows you how to upload firmware and configuration files. You can
upload configuration files by following the procedure
page
Maintenance – Upload System Configuration File.

Firmware file upload

FTP is the preferred method for uploading the firmware and configuration. To use
this feature, your computer must have an FTP client.
When you use Telnet to access the BCM50a Integrated Router, the screens for
uploading firmware and the configuration file using FTP appear.
Chapter 15 Firmware and configuration file maintenance 169
Chapter 17, "Remote Management," on page 185
167, or by following the instructions in Menu 24.7.2 – System
Warning: Do not interrupt the file transfer process as this can
permanently damage your
BCM50a Integrated Router.
BCM50a Integrated Router Configuration — Advanced
to read about
"Restore configuration" on